TRB Ball rods

spare parts2019

Ball to ball or ball to connector rods, spare parts to configure or upgrade our rigging system.

This ball ending rods came in different lenghts and endings to allow maximum flexibility configuring the rig according to its function. All them are connected to each other using the joint or articulation (J6, DJ9 and J12). This part has been CNC machined from stainless steel to ensure its roundness and allow a fluid rotation inside the J6 articulation, according to the industry standards UNE-EN ISO 9001.

The ball dimensions on all CNC parts from this page are  0,2 mm smaller than nominal size. So for a 6mm rod the ball is 5.8mm in order to clean the rod outside and get a full round ball. Same for  5,8 mm / 8,8 mm and 11,8mm. All Kinetic Armatures joints work fine with this variation in diameter but we don’t recommend to mix our ball rods and ball bearings in the same double ball joint. It will still work but the ball bearing side will be slightly more compressed than the other side.



TRB Ball rods

TRB ball & TRB ball-ball rods

CNC machined stainless steel
6mm, 9mm and 12mm diameter rods


Clear selection

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.